We are finally getting very close to the release of Proteus and to prepare people Imeo has made a video showing the changes he has made. I've posted the video here for you to watch as it would take far too long to explain everything properly. Instead I am copying below the instructions from the Proteus thread on ECFby Imeo with help from proteckt3d. Along with the video it should give you a good idea of how VIR/Proteus works.
Instructions for Proteus
PROTEUS IS IN YOUR HANDS:
1. To install a battery, unscrew the brass part and insert an 14500 IMR battery, positive side up. Screw the brass part again. If the battery is not making contact, please unscrew the venting cap and adjust the small brass bolt inside it.
2. Wait 6 seconds until Proteus locks (you will see green light blinking a few times and then a blue light will stay on for 2 seconds).
3. Connect an atomizer on Proteus which has a Titanium grade 1 coil.
4. Unlock Proteus by pressing 5 quick times the button. You will have a red light blinking slowly. Dont interfere with the device during this procedure. After blinking stops (in about 25 sec on a cold atomizer or in about 1 minute on a very hot atomizer), you will have a fixed orange light that stays on for about 2 seconds and shows that auto detection function is finished.
5. Push the button to vape.
LIGHTS THAT WILL APPEAR DURING VAPING:
1 short red blink: You vape at lower temperature because battery cannot sustain the set temperature level.
10 green fast blinks: Your atomizer is bad fed or its running out of liquid, so you have to refill it. Especially on GG atomizers, you can just open the liquid control. If the problem persists, you have to refill.
5 slow white blinks: The charge in the battery is getting low and soon it will be discharged completely. Change your battery or go to a lower temperature step.
Blue light is steady on for 2 seconds: Proteus is locked because the button was pushed for more than 15 seconds (press button 5 times to unlock it).
10 red fast blinks: Short circuit, meaning that your atomizer has a lower resistance than VIR can handle, or your atomizer is shorting. Check your atomizer or make a new coil. Before you make a new coil, wash your atomizer under running water to remove any small pieces of wires that may be shorting it.
MENU:
Note: The range of the working temperature is 180-280 Celsius degrees. Proteus remembers the temperature setting and all your settings in general after battery is changed.
Up menu - Increase temperature level: push 3 times and keep the button pushed for 1 sec. The red light will stay on. While its on, push the button 1 time to increase the temperature 10 Celsius degrees, 2 times for 20 Celsius degrees increase, etc
Down menu-Decrease temperature level: push 4 times and keep the button pushed for 1 sec. The green light will stay on. While its on, push the button 1 time to decrease the temperature 10 Celsius degrees, 2 times for 20 Celsius degrees decrease, etc
Lock Proteus: push the button 5 times (blue light stays on for 2 seconds)
Unlock Proteus: push the button 5 times (blue light blinks 3 times)
Check set temperature: Go to either the Up or Down menu and when either the red or the green lights turn on, release the button. An orange light will start blinking slowly, each blink indicating one step in temperature ( 10 Celsius degrees). The total number of blinks will let you know what temperature you are at.
Stop led's blinkings in general: push 1 time the button
CHANGING ATOMIZER:
If you want to vape again on the same atomizer (or without changing the coil on it), lock Proteus - disconnect the atomizer - connect it again when you are ready. Unlock and vape
If you want to vape with a different atomizer (or with the same atomizer in witch you changed the coil), let Proteus lock by itself - connect the new atomizer - unlock - wait until orange light turns on (after 25 sec-1 min, depending of how cold or hot the atomizer is) and vape.
CLEANING:
Keep threads and contacts clean, otherwise your Proteus will not work as you expect.
I am sure once people get Proteus in their hands it won't take too long to figure out how to use it. From what I saw in the video it's looking very good and working very well and the best news is it is not too far away now.
0 comments :
Post a Comment